Repetition; Start Value - Reiner jetStamp 790 Mode D'emploi

jetStamp 790/790 MP

2.1.4. Repetition

Defines the number of times an imprint is repeated. If, for example, the value "03" is set,
the numberer prints the same number three times before counting further.
Press [MODE] until [NO/TXT] appears in the display menu bar.
f
Press [NO/TXT].
f
"INPUT - REPETITION" appears.
To change the unit value of the number, press [VARY].
f
To increase the number value, press [INC].
f
To decrease the number value, press [DEC].
f
To change the tens value of the number, press [LEFT].
f
To increase the number value, press [INC].
f
To decrease the number value, press [DEC].
f
To save changes and to return to the main menu,
f
press [RETURN] twice.
The main menu appears.

2.1.5. Start value

Defines the required number start value. If, for example, the value "15" is set,
the numberer stamps, starting from this value.
Press [MODE] until [NO/TXT] appears in the display menu bar.
f
Press [NO/TXT].
f
Press [NEXT] until "INPUT - NUMBERER 1" appears.
f
Press [VARY].
f
To increase the number value, press [INC].
f
To decrease the number value, press [DEC].
f
In order to move one digit to the left and modify this with [INC/DEC],
f
press [LEFT].
Special characters that don't change when counting, can be defined from the
2nd digit position from the right, e.g hyphen, slash, space.
To save changes and to return to the main menu,
f
press [RETURN] twice.
The main menu appears.
66