Publicité
Les langues disponibles
Les langues disponibles
Offline Voice Control Puck with Wireless Charger
Follow the installation steps below to setup the puck device.
Step 1
Please take a minute to familiarize yourself with the voice commands listed on
the next page.
Step 2
Remove The Puck from the box.
Step 3
Use the remote control to lift the HEAD to
the maximum angle.
Step 4
Locate the connector secured to the corner of the frame and connect it with
the Puck Voice Control plug as shown in the picture.
10
Step 5
The Puck Voice Control will arrive in the Off
position and you will need to activate the Puck
by selecting an invocation command of your
preference.
Use the slider switch on the back side of the
Puck to select the invocation phrase you wish to
use, either "HELLO ERGO" or "HELLO MOTION".
Use the bottom slider switch to select your
preferred language for giving voice commands.
Note: If you have a split base, each side must
have a different invocation phrase in order to
work independently.
WAKE UP DEVICE
To use the Puck Voice Activated System, simply say the invocation command
you chose during setup, either "HELLO ERGO" or "HELLO MOTION", and wait
1-2 seconds for the microphone to activate. Once the microphone is activated,
indicated by the blue light, it will be active for 8 seconds. While the microphone
is active you can now use any of the voice commands listed below to control
your adjustable base. If no command is heard within 8 seconds, the Puck will
enter "sleep mode" and the microphone will be deactivated.
Publicité
