Tennant VLX 2911SR Manuel D'instructions page 60

2 AUTOMATIC, the solution flow is set by the machine according to the speed
(STANDARD MACHINE ONLY).
3 ECONOMY, the solution flow is fixed at the lowest level (STANDARD MACHINE
ONLY).
4 CHEM-DOSE STANDARD MACHINE, enables the solution tank pump
(OPTIONAL). To enter CHEM-DOSE mode, hold the button (fig. A, ref. 3) down
until the red LED corresponding to CHEM-DOSE comes on. To vary the quantity of
solution, you must first disable the programmes (STANDARD, AUTOMATIC,
ECONOMY) by pressing the button (fig. A, ref. 3). The quantity of solution can now
be adjusted using the buttons (fig. A, ref. 2) and the value set appears on the
display (fig. A, ref. 6). Once the quantity of solution has been set, the most suitable
type of solution flow must be selected (STANDARD, AUTOMATIC, ECONOMY)
using the button (fig. A, ref. 3). To disable the solution tank pump, hold the button
(fig. A, ref. 3) down for at least five seconds until the LED corresponding to CHEM-
DOSE goes out.
5 CHEM-DOSE MICRO SCRUB / ECS MACHINE enables the solution tank pump
(OPTIONAL). To enter CHEM-DOSE mode, hold the button (fig. A, ref. 3) down
until the red LED corresponding to CHEM-DOSE comes on. To vary the quantity
of solution, you must first disable the programmes (STANDARD, AUTOMATIC,
ECONOMY) by pressing the button (fig. A, ref. 3). The quantity of solution can now
be adjusted using the buttons (fig. A, ref. 2) and the value set appears on the
display (fig. A, ref. 6). Once the quantity of solution has been set, for BRUSH-PAD
mode only, the most suitable type of solution flow must be selected (STANDARD,
AUTOMATIC, ECONOMY) using the button (fig. A, ref. 3). When using CHEM-
DOSE in MICROFIBRE mode, you cannot use the STANDARD, AUTOMATIC and
ECONOMY programmes. To vary the flow, use the buttons (fig. A, ref. 2) only. To
disable the solution tank pump, hold the button (fig. A, ref. 3) down for at least five
seconds until the LED corresponding to CHEM-DOSE goes out.
6 MICROFIBRE, the solution flow can be varied using the buttons (fig. A, ref. 2)
(MICRO SCRUB / ECS MACHINE ONLY)
•
Start cleaning, manoeuvring with the hands on the steering wheel (fig. B, ref. 9) and
moving the machine forwards or backwards by pressing the pedal (fig. B, ref. 7).
•
The working speed can be set using the maximum speed regulator (fig. A, ref. 13).
•
Models with roller brushes: empty the debris bin (fig. O, ref. 5) by extracting it
sideways. Empty the debris and wash.
To avoid damaging the surface of the floor to be treated, avoid rotating the
brushes/pads/microfibre disks with the machine stationary.
Machine fitted with flashing light accessory: when the machine is operating, the
flashing light works continuously.
Stopping:
•
Release the pedal (fig. B, ref. 7)
•
The machine does not have a parking brake as it is fitted with an electromagnetic
brake which automatically brakes the machine when the drive pedal is not pressed.
•
To stop all functions, press the brush button (fig. A, ref. 8).
•
Turn the main switch (fig. A, ref. 1) to the "0" position.
 IMPORTANT
i INFORMATION
ENGLISH
17