Zanussi ZDLN7531 Notice D'utilisation page 11

Multi-tabs containing salt are not
effective enough to soften hard water.
Regeneration process
For the correct water softener operation, the resin
of the softener device needs to be regenerated
regularly. This process is automatic and is the part
of the normal dishwasher operation.
When the prescribed quantity of water (see values
in the table) has been used since the previous
regeneration process, a new regeneration process
will be initiated between the final rinse and the
programme end.
Water softener level
1
2
3
4
5
6
7
8
9
10
In case of the high water softener setting, it may
occur also in the middle of the programme, before
the rinse (twice during a programme). Regeneration
initiation has no impact on the cycle duration,
unless it occurs in the middle of a programme or at
the end of a programme with a short drying phase.
In that cases, the regeneration prolongs the total
duration of a programme by additional 5 minutes.
Subsequently, the rinsing of the water softener that
lasts 5 minutes may begin in the same cycle or at
the beginning of the next programme. This activity
increases the total water consumption of a
programme by additional 4 litres and the total
energy consumption of a programme by additional
2 Wh. The rinsing of the softener ends with a
complete drain.
Each performed softener rinse (possible more than
one in the same cycle) may prolong the programme
duration by another 5 minutes when it occurs at any
point at the beginning or in the middle of a
programme.
Amount of water (l)
250
100
62
47
25
17
10
5
3
3
All the consumption values mentioned
in this section are determined in
accordance with the currently
applicable standard in laboratory
conditions with water hardness
2.5mmol/L according to the
2019/2022 regulation (water softener:
level 3).
The pressure and the temperature of
water as well as the variations of the
mains supply can change the values.
THE RINSE AID LEVEL
The rinse aid helps to dry the dishes without
streaks and stains. It is automatically released
during the hot rinse phase. It is possible to set the
released quantity of rinse aid.
When rinse aid chamber is empty, the rinse aid
indicator is on notifying to refill rinse aid. If the
drying results are satisfactory while using multi-
tablets only, it is possible to deactivate the
dispenser and the indicator. However, for best
drying performance, always use rinse aid and keep
the rinse aid indicator active.
To deactivate the rinse aid dispenser and indicator,
set the level of rinse aid to 0A.
END SOUND
You can activate an acoustic signal that sounds
when the programme is completed.
Acoustic signals sound also when a
malfunction of the appliance occurs. It
is not possible to deactivate these
signals.
AIRDRY
AirDry improves the drying results. The appliance
door opens automatically during the drying phase
and remains ajar.
11