Publicité
Les langues disponibles
Les langues disponibles
EN
2.1.3.Assembling the drive-tube
1] Slide the drive into the tube. Insert the wheel by aligning the wheel to the tube
profile. Insert the drive half way and then slide the crown down the drive and
insert it in the tube. Finally, push the motor inside the tube.
2] Not required, but if needed, fix the tube to the drive with self-tapping screws
or steel pop rivets depending on the dimension (L).
2.1.4.Mounting the tube-drive assembly on the brackets
(a) Standard bracket.
(b) Drive plate for specific bracket.
NOTICE
For optimal radio reception, the motor antenna should be kept straight and should be positioned outside of headrail
(if used).
2.2.Wiring
PRECAUTION
• To ensure electrical safety, this Class III motor must be powered by a "class 2" power source [SELV -Safety Extra
Low Voltage) + LPS (Limited Power Supply)]
• Improper using battery pack may cause overheat, fire, explosion, resulting in serious injury or death.
CAUTION
• For the purposes of recharging the battery, only use the detachable supply unit provided with this appliance.
• Ensure battery is fully charged prior to installation on site.
• Using this drive with any products which are not listed in the attached «Compatibility matrix» document shall also
render invalid any Somfy warranty and release Somfy from any liability.
1] Connect the charger to the drive.
2] When charging is complete, disconnect and store charger for later use.
Motor LED illuminates
Green LED blinks.
Solid Green.
2.3.Commissioning
NOTICE
• The orange LED blinks continuously in setting mode.
• To save battery power, if no Zigbee network is detected after a few minutes, the drive will stop searching for a network
and the LED will turn off. Briefly press the programming button on the drive head to reactivate the search.
• Green LED blinks once when any order from paired product or application is received.
2.3.1.Waking up the drive
1] For initial unpackaging of drive, wake up the drive by briefly pressing the
motor head programming button or plugging on the charger.
g The motorised product briefly moves up and down and green LED lights
on for 2 seconds.
4
Behaviour
Charging.is in progress
Charging is complete.
Copyright
Sonesse ULTRA 30 WF Zigbee Li-ion
1]
2]
(a)
(b)
©
2021 SOMFY ACTIVITES SA. All rights reserved.
Publicité
