Publicité
Les langues disponibles
Les langues disponibles
machines carries an increased risk of accident (laceration or cut hazards due to uncontrolled
reactions of the chainsaw).
User manual
Before first commissioning, carefully and fully read the manual. Keep it in a safe place for future
information.
5.2- Working with the chainsaw
WARNING
5.3- Guard against kickback
- This saw is equipped with a chain brake that will stop the chain in the event of kickback if
operating properly.
You must check the chain brake operation before each usage by running the saw at full the throttle
for 1-2 seconds and pushing the front hand guard forward. The chain should stop immediately with
- Before proceeding to your job, read the section "Safety".
It is recommended to first practice sawing easy logs. This also helps you get
accustomed to your machine.
- Always follow the safety regulations. The chain saw must only be used for
cutting wood.
It is forbidden to cut other types of material. Vibrations and kickback vary
with different materials and the requirements of the safety regulations would
not be respected. Do not use the chain saw as a lever for lifting, moving or
splitting objects. Do not lock it over fixed stands. It is forbidden to hitch tools
or applications to the PTO (driveshaft) other than those specified by the
manufacturer.
- It is not necessary to force the saw into the cut. Apply only light pressure
while running the engine at full throttle.
- When the saw chain is caught in the cut, do not attempt to pull it out by
force, but use a wedge or a lever to open the way.
- If the guide bar and saw chain becomes caught in wood while operating it,
stop the engine. Do not pry the handle with excessive force. Use a wedge to
remove the chain instead.
ATTENTION! National or local regulations may restrict the use of the
machine at certain times. Check with your local authority
Note: careful daily inspection should be performed before use and after a drop
or shock to identify major defects.
Do not use the machine until the defects have been repaired.
Restrict working hours to a minimum and always take rest periods.
For proper use, after each work period take a rest period (for ex take a rest for
10 minutes after a work period of 30 minutes).
Publicité
