Publicité
Les langues disponibles
Les langues disponibles
VI. MAINTENANCE AND STORAGE
WARNING - Before cleaning, the inspecting or repairing the unit, make sure that engine has
stopped and is cool.
Disconnect the spark plug to prevent accidental starting.
Reminder: Make sure to maintain the machine in good working condition, carry out regular
maintenance of the machine after each use and before storage.
Any breach or default of adequate maintenance reduces the life of the machine and increases the
risk of breakdowns and accidents.
To preserve the security system throughout the life of the machine, it is important to perform
maintenance and proper cleaning, DO NOT use non-compliant replacement parts and do NOT
dismantle yourself the machine or change the security features.
6.1- Maintenance after each use
6.1.1- Air filter
Loosen the knob and remove the air cleaner cover.
Take off the filter elements and tap off attached sawdust.
When they are extremely dirty, shake wash with gasoline.
Dry them completely before reinstalling.
6.1.2- Oiling port
Dismount the guide bar and check the oiling port for
clogging.
6.1.3- Guide bar
When the guide bar is dismounted, remove sawdust in the
bar groove and the oiling port.
Grease the sprocket nose from the feeding port on the tip of
the bar.
6.1.4- Others
Check for fuel leakage and loose fastenings and damage to major parts, especially handle joints and
guide bar mounting.
If any defects are found, make sure to have them repaired before operating the saw again.
6.2- Periodical service points
6.2.1- Cylinder fins
1. Remove the starter case.
2. Remove sawdust between the cylinder fins.
3. Clean the volute area.
6.2.2- Fuel filter
(a) Using a wire hook, take out the filter from the filler port.
(b) Wash the filter with gasoline.
Replace with new one if clogged with dirt completely.
WARNING - When returning the filter, use a pinch not to be
folded the suction pipe.
Publicité
