Sony CDX-3201DAB Mode D'emploi page 22

NO SERV (no service)
The DAB signal cannot be received.
 Perform an auto scan (page 8).
 Check the connection of the DAB antenna
(aerial).
 Check that [SET ANT-PWR] is set to [ON]
(page 13).
NO TP: No traffic programs.
 The unit will continue searching for
available TP stations.
NOT SUPPORT - ANDROID MODE
 A USB device not supporting AOA
(Android Open Accessory) 2.0 is
connected to the unit while [USB MODE] is
set to [ANDROID].
– Set [USB MODE] to [MSC/MTP] (page 13).
OVERLOAD: The USB device is overloaded.
 Disconnect the USB device, then press SRC
to select another source.
 The USB device has a fault, or an
unsupported device is connected.
READ: Now reading information.
 Wait until reading is complete and
playback starts automatically. This may
take some time depending on the file
organization.
RECEIVING
 The DAB band is selected and the unit is
waiting to receive a service.
USB ERROR: The USB device cannot be
played.
 Connect the USB device again.
USB NO DEV: A USB device is not connected
or recognized.
 Make sure the USB device or USB cable is
securely connected.
USB NO MUSIC: There is no playable file.
 Connect a USB device containing playable
files (page 18).
USB NO SUPRT: The USB device is not
supported.
 For details on the compatibility of your
USB device, visit the support site on the
back cover.
22
GB
or : The beginning or the end
of the disc has been reached.
(underscore): The character cannot be
displayed.
For steering wheel remote control
operation:
ERROR: An error occurred during the
function registration.
 Register again from the function where
the error occurred (page 13).
TIMEOUT: The function registration failed
due to a timeout.
 Try completing the registration while
[REGISTER] is blinking (about 6 seconds)
(page 13).
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
If you take the unit to be repaired because of
CD playback trouble, bring the disc that was
used at the time the problem began.