Wiring Diagram; Electronic Dhw Hp Controller; User Interface - Weider BWP 270 0A Mode D'emploi Et D'installation

WIRING DIAGRAM:

ELECTRONIC DHW HP CONTROLLER

USER INTERFACE:

2-line display (The Control Panel setup, see also control panel drawing on page 7).
Water
The upper line displays the parameter menu (function).
45°C
The bottom line displays the parameter status or value.
The display is activated (indicated) by turning or pressing the rotary-/push button (no. 32 on the control panel drawing).

To scroll through the menu turn the rotary-/push button.

You have 12 menus. The far left is the menu "WATER" (indicates the actual DHW temperature).

If you want to change the status or value of a parameter, push shortly the rotary-/push button; the status/value line will

now start flushing. While the display is flushing you can vary the status/value by turning the rotary-/push button. When
the desired value is indicated push the rotary-/push button again to acknowledge the chosen status/value. If you don't
acknowledge the value while the display is flushing, the status/value remains unchanged.
If you press t the rotary-/push button for more than 3 seconds, you get to the service parameter menu. This expert menu

is reserved for the installer. Please do not change these settings without consulting your installer. None authorized
settings in this menu might be the cause of warranty exclusion.
13