Ergomotion Ergo Box Manuel Du Propriétaire page 5

Safety Precautions and Usage Statements
TOLERANCE
®
All ergomotion adjustable foundations, depending on make and
model, are designed and manufactured to perform and function within
designated quality control parameters. Bases are subject to meticulous
and rigorous inspections during the quality control process to ensure
bases will operate within these standards during normal operating use.
Normal operating use is defined as the following: Adjustable foundation
is to be operated with a mattress and load. Testing procedures require
lifetime cycle tests with up to 120kg distributed load. The angle
(designated "α" in figure 1) between the back section and the flat section
for various configurations of the mattress support platform shall be ± 3°,
which translates to a tolerance of up to 38mm.
The angle (designated "β" in figure 1) between the flat section and foot
section for various configurations of the mattress support platform shall
be ± 3°, which translates to a tolerance of up to 19mm.
Any adjustable foundation deemed to be within these allocated
tolerances is considered to have met the manufacturer's quality control
standards.
ACOUSTICS:
In normal base operation the wheels, which allow the bed to maintain its
distance from the wall, will make contact with the steel platform supports
of the base creating a contact noise. When entering, exiting or shifting
weight on the base, this contact noise may be audible as the wheels
make contact. This is normal.
PAIRED OPERATION:
When operating a "paired" split base setup there may be a time latency
up to 1.5 seconds between each bases articulation.
WEAR AND TEAR:
Wear and tear is damage that naturally and inevitably occurs as a result of
normal use or aging.
FABRIC CARE:
To prolong the life of your fabric, protect from direct sunlight whenever
possible. For spot cleaning, wipe area with a light damp sponge or
vacuum with a soft brush attachment to remove particles. Keep at a
minimum of 30cm (12 inches) away from direct heat sources. For a
deeper cleaning, blot liquid spills with a clean dry cloth. Wipe with a clean
cloth dampened with warm water. Do not wet excessively. A soft bristle
brush may be used to remove ingrained soil. Avoid scratching by gentle
brushing. Wipe with a clean cloth dampened with warm water to remove
residues. Dry in shade away from direct heat. If persistent marks remain
visible after cleaning, seek professional advice.
PRODUCT RATINGS:
The lift motors are not designed to operate continuously for more than
[2] minutes in an [18] minute time period or approximately 10% duty
cycle. Attempting to circumvent or exceed this rating will shorten the life
expectancy of the product and may void the warranty. The massage
motors are not designed to operate continuously for more than 30
minutes at a time. Please allow the massaging system to rest for 30
minutes after automatic massage shut off before restarting.
WEIGHT LIMITS:
This product is not rated to support weights in excess of 750 pounds
(340kg) inclusive of the mattress and bedding. The base will structurally
support this weight, provided it is evenly distributed across the bed base.
The adjustable base is not designed to support or lift this amount in
the head or foot sections alone. Exceeding this weight restriction could
damage the bed and/or cause injury and will void the warranty.
Exceeding this weight restriction could damage the bed
and/or cause injury and will void the warranty.
3