Ergomotion Ergo Box Manuel Du Propriétaire page 21

Remote Control Pairing
The original remote that comes in the box is already paired to the adjustable base. No further action is required. In the
event that the remote is not paired with the base, follow the steps below.
STEP 1
Remove rear cover of the remote control by sliding it down to expose
the PAIR button. Unplug the Power Cord from your power outlet. Wait 1
minute, then plug it back in to your power outlet. Perform Step 2 within
10 seconds, while the control box light is flashing.
Power Supply
Power Cord
STEP 2
On the back of the remote, press
and hold the PAIR button. The
PAIR button will illuminate blue
and start flashing. When the PAIR
button stops flashing, the green
LED light on the control box will
go out. Release the PAIR button.
The remote is now paired to the
adjustable base.
STEP 3
Test all remote functions. If the remote buttons do not impact the
adjustable base movements, please repeat the process again or
call customer service: 1-888-550-3746
19