COMPONENTS
FIG. 5
U
N
O
A - Output Ready LED
B - Overload LED
C - Low Oil LED
D - Service Generator LED
E - Automatic Shutoff LED
F - Reset Button
G - ECO Mode Switch
UNDERSTANDING YOUR GENERATOR
See Figure 5.
To reduce the risk of injury and product failure, read and
understand the information in this user's manual as well as
the information on the product labeling.
120 VOLT AC, 20 AMP RECEPTACLE
This unit has two single phase, 60 Hz receptacles capable
of carrying a maximum of 20 amps.
ACCESSORY TRAY
The accessory tray is ideal for storing cell phones, tablets,
and other devices while they charge. DO NOT stand near
generator while your device charges. Always maintain
a safe distance while the generator is in use.
CIRCUIT BREAKER (20 AMP)
The 20 amp circuit breaker protects devices and equipment
connected to the 120V receptacle from electrical overload.
F
G
A
B
B
C
D
E
M
H - 120 Volt AC 20 Amp Receptacles
I - 20 Amp Circuit Breaker
J - LED light
K - Parallel Operation Outlets
L - USB Ports
M - Ground Terminal
N - Engine/Fuel Control Switch
H
R
S
CO SENSOR INDICATOR LIGHTS
The CO Sensor monitors for the accumulation of poisonous
carbon monoxide gas. If increasing levels of CO gas are
detected, the CO Sensor automatically shuts down the
engine.
ECO MODE SWITCH
Eco mode minimizes fuel consumption and noise by
adjusting the engine RPM to the minimum required for the
current load.
ENGINE/FUEL CONTROL SWITCH
Rotate the engine/fuel control switch to set the choke and
start or stop the flow of fuel.
ENGINE SERVICE PANEL
Turn the lock knob to unlock and remove cover to service
the oil, spark plug, and air filter.
K
L
I
J
P
O - Recoil Handle
P - Vented Fuel Cap
Q - Spark Plug Service Door
R - Engine Service Cover
S - Lock Knob
T - Muffler/Spark Arrestor
U - Accessory Tray
Q
T
English | 11