Harman Kardon HK3550 Manuel Du Propriétaire page 9

Using the Preset Buttons
Your receiver allows you to store 30
station settings and quickly access
them, using the 10 Preset buttons. The
preset stations are designated by the
number from 1 to 30. Any designation
may be used for any AM or FM station,
in whatever combination you choose.
To enter a station in memory:
1. Tune to the desired station.
2. Be sure the Seek-Stereo setting is the
one desired".
3. Press the Memory switch. ("PRESET"
will flash for about 3 seconds.)
4. With "PRESET" flashing, press the
desired numbered Preset button. If a
preset of "10" or greater is to be
entered, enter the 1, 2 or 3 for 10, 20
or 30 first, then within 3 seconds enter
the last digit (0 — 9).
*NOTE: When a station is set in
memory, the Seek-Stereo setting is also
entered. Subsequently, each time a
station is recalled using a Preset button,
the tuner automatically switches to the
original Seek-Stereo setting for that
station.
Memory
Seek-Stereo
To change a preset station:
Simply enter the new station. The old
station is automatically erased.
To access a preset station:
Press the desired numbered Preset
buttons.
NOTE: Preset stations are stored
indefinitely while the unit is connected to
a live AC source, and for approximately
3 weeks when the unit is unplugged.
Making a Recording
When you select Video, Tuner, CD,
Phono or Aux as your sound source,
recordings may be made on tape deck 1
or 2, or both simultaneously. When
making recordings on tape decks 1 and
2 simultaneously, you may listen directly
to the source, or you may monitor tape
deck 2. DO NOT monitor tape deck 1
during this procedure.
If you wish to copy a tape, place it in
deck 1, and press the Tape 1 button on
your receiver. You may then record the
tape using tape deck 2.
Tapet/Copy Tape2/Mon.
LI
NOTE 1: To turn off the Tape 1
selection, press either Video, Tuner, CD,
Phono or Aux. To turn off the Tape 2,
press Tape 2 again.
NOTE 2: To use a 3-head tape deck that
allows monitoring of the actual recording
while it is in process, you must connect it
to TAPE 2 jacks. Pressing Tape 1 will
switch off the source.