Harman Kardon HK3550 Manuel Du Propriétaire page 7

Indicates that Tape 2 has
been selected. !n this case,
only the output of the tape
deck connected to the
TAPE 2 jacks can be heard.
Shows Seek function
is on and stereo
reception is possible.
Flashes during the period
when a station can be
entered into memory.
Indicates that power
cord is connected to an
AC receptacle and that
the unit is switched off.
"inaAeCOMtCASD PEAR TO NI ITAMSES
'
/ indicates station is
/ properly tuned. Shows when a Preset
station is selected.
Shows stereo broadcast
is being received. In the tuner mode, AM or FM
band and frequency of the tuned
station is indicated. When other
sources are selected, the name
of the source is indicated.
DISPLAYS and REMOTE CONTROL
—
Tuner FM/AM Seek-St P.Sc
y
S 3
OO
Bete
>
Tape <<
a | a | ae
harman/kardon
Stereo Receiver
RAYIOD
(HK3550/HK3450's remote control shown)
Independent Remote Control
The keys on the remote control unit
function the same as the corresponding
buttons on the receiver itself.
Operating Conditions
The control unit operates effectively
within a distance of 7 meters and an
angle of 30° from the receiver. Using the
control near fluorescent lights may
shorten this range, as will any dust or
dirt that accumulates on the front of the
remote control, or the remote sensor
area of the receiver. Also avoid blocking
the line of sight between receiver and
remote.
The control unit is powered by two AA
batteries, included with your receiver.
When you replace weak batteries,
replace both at the same time. When the
remote is to be unused for an extended
period, remove the batteries to prevent
damage from corrosion.