Télécharger Imprimer la page

MW TOOLS BG25M Mode D'emploi page 42

Publicité

Les langues disponibles

Les langues disponibles

6 Starting the engine / Stopping the engine
6�1 Starting the engine
1. Make sure that the AC circuit breaker is in the OFF position. The generator may be hard to start if a load is connected.
2. Turn the fuel valve lever to the ON position.
3. Turn the choke rod to the CLOSED position.
4. Move the engine switch to the ON position.
5. Pull the starter grip lightly until resistance is felt, then pull briskly.
CAUTION!
Do not allow the starter grip to snap back against the engine� Return it gently to prevent damage
to the starter or housing�
6. As the engine warms up, slowly push the choke rod to the OPEN position.
6�2 Stopping the engine in an emergency
To stop the generator in an emergency, turn the engine switch to the OFF position.
6�3 Stopping the engine in normal use
Always do as the following so as to keep the generator in a sound condition.
Always do as the following so as to keep the generator in a sound condition.
1. Turn the AC circuit breaker to the OFF position.
2. Turn the engine switch to the OFF position.
3. Turn the fuel valve lever to the OFF position.
W W A A R R N N I I N N G G
W W A A R R N N I I N N G G
1. Always connect the generator
1. Always connect the generator
7 Service
to the earth or the Recreational
to the earth or the Recreational
1. Always connect the generator to the earth or the
vehicles to prevent misusing with wire.
vehicles to prevent misusing with wire.
recreational vehicles to prevent misusing with wire.
Don't move the earth wire during normal
Don't move the earth wire during normal
maintenance or repair.
maintenance or repair.
Don't move the earth wire during normal maintenance or repair.
M1.1.BG25M-BG30M-BG50E-BG65ED-BG75E.NLFREN - 11062020
2.If the generator is to supply tow or above loads
2.If the generator is to supply tow or above loads
with power supply, be sure to connect them one
with power supply, be sure to connect them one
2. If the generator is to supply tow or above loads with power
with higher start current fist.
with higher start current fist.
supply, be sure to connect them one with higher start current fist.
1
1
42
EN
S S E E R R V V I I C C E E
S S E E R R V V I I C C E E

Publicité

loading