MW TOOLS BG25M Mode D'emploi page 38

3�2 Fuel valve lever
The fuel valve is located between the fuel tank and carburettor. When the valve lever is in the ON position, fuel is allowed to
flow from the fuel tank to the carburettor. Be sure to return the fuel valve lever to the OFF position after stopping the engine.
3�3 Choke rod
The choke is used to provide an enriched fuel mixture when starting a cold engine. It can be opened and closed by operating
the choke lever manually. Pull the rod out toward CLOSED to enrich the mixture for cold starting.
3�4 Ground terminal
The generator ground terminal is connected to the frame of the generator, the metal non-current-carrying parts of the generator,
and the ground terminals of each receptacle.
Before using the ground terminal, consult a qualified electrician, electrical inspector or local agency having jurisdiction for local
codes or ordinances that apply to the intended use of the generator.
3�5 Oil alert system
The oil alert system is designed to prevent engine damage caused by an insufficient amount of oil in the crankcase. Before the
oil level in the crankcase can fall below a safe limit, the Oil Alert system will automatically stop the engine (the engine switch
will remain in the ON position). The Oil Alert system should not take place of checking the oil level before each use.
If engine stops or not restart, check the engine oil level before troubleshooting in other areas.
A A C C C C I I R R C C U U I I T T B B R R E E A A K K E E R R
3�6 AC Circuit breaker
The AC circuit breaker will automatically switch OFF if there is a short The AC circuit breaker will automatically switch OFF if there is a short circuit or a significant
overload of the generator at the receptacle.
circuit or a significant overload of the generator at the receptacle.
If the AC circuit breaker is switched OFF automatically, check that the appliance is working
properly and does not exceed the rated load capacity of the AC circuit before switching the
If the AC circuit breaker is switched OFF automatically, check that
circuit breaker ON again.
The circuit breaker may be used to switch the generator AC power ON or OFF.
the appliance is working properly and does not exceed the rated
load capacity of the AC circuit before switching the circuit breaker
ON again.
The circuit breaker may be used to switch the generator AC power ON or OFF.
Closed
6 6
M1.1.BG25M-BG30M-BG50E-BG65ED-BG75E.NLFREN - 11062020
C C O O N N T T R R O O L L S S
Choke lever
38
C C O O N N T T R R O O L L S S
EN
C C O O N N T T R R O O