Progress PK1240 Notice D'utilisation page 26

26 progress
1. Remove the hinge cover and install it on
the opposite hinge.
2. Install the lower spacer.
3. Tighten the lower pin.
4. Install the door.
5. Install the upper spacer.
6. Tighten the upper pin.
Ventilation requirements
The airflow behind the appliance must be
sufficient.
min.
200 cm
Furniture alignment
Important! Make sure that the kitchen
furniture is aligned vertically and at 90° in all
directions.
Adjust the kitchen furniture doors before in-
stalling the appliance.
2
min.
200 cm
2
Important! Remove the furniture door
damper if possible, to provide free space for
the free movement of the appliance door.
Installing the appliance
Caution! Make sure that the mains
cable can move freely.
Do the following steps:
1. Install the sealing strip.
a) Remove the strip cover.
b) Apply the adhesive sealing strip to
the appliance as shown in figure.
90° 90°
min 1 mm