Télécharger Imprimer la page

Mitsubishi Electric TRANE NTXAMT12A112AA Manuel D'installation page 40

Masquer les pouces Voir aussi pour TRANE NTXAMT12A112AA:

Publicité

Les langues disponibles

Les langues disponibles

13.2. Connecting line voltage
Make sure power supply is off.
13.2. Connecting line voltage
The unit should be installed by a licensed contractor/
electrician. If required by applicable national, state and
Make sure power supply is off.
local codes; a disconnect switch will need to be installed
The unit should be installed by a licensed contractor/electrician. If required by applicable national, state, and local
when the indoor unit is powered from the outdoor unit.
codes, a disconnect switch will need to be installed when the indoor unit is powered from the outdoor unit.
Remark:
* Use a ring tongue terminal in
order to connect a ground wire
to terminal.
Grounding Terminal*
NOTE: If the air handler will be installed with electric heat
package do not power the electric heat from the outdoor unit.
NOTE
If the air handler will be installed with electric heat package do not power the electric heat from the
All wiring must conform to National and Local codes
outdoor unit.
All wiring must conform to national and local codes
1. Remove the desired knockout on the air handler.
Function Table
2. Attach a conduit pipe connector to the air handler and route the wiring as shown in the above diagram. Ensure conduit
connection hole is air tight and add a sealant if necessary.
3. Firmly tighten all of the terminal screws. After tightening, verify that the wires are tightly fastened.
Mode
Power failure auto
restart
Indoor temperature
Specifications are subject to change without notice.
detecting
NTXAMT12, 18, 24, 30, 36A112AA
Grounding Terminal*
Not available
Available
Indoor unit operating average
Set by indoor unit's remote controller
Remote controller's internal sensor
Grounding
terminal*
Disconnect
switch
Settings
40
© 2018 Mitsubishi Electric Trane HVAC US LLC. All rights reserved.
1. Remove the desire
2. Attach a conduit pip
wiring as shown in the
hole is air tight and ad
3. Firmly tighten all of
that the wires are tigh
Electrical Character
Symb
IFM : I
Model
Hz
A12
A18
A24
60
208/2
A30
A36
Mod
Vo
W
(R

Publicité

loading