Caso Germany HCMG 25 Mode D'emploi page 59

• The electrical socket must be easily accessible so that the power lead
can be disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup
locations (e.g. on ships) must be carried out by specialist companies /
electricians, provided they guarantee the prerequisites for the safe use
of this device.
11.5.2
•
c) Do not remove the feet from the bottom of the appliance.
needed, and on the sides at least 20 cm distance to other walls or units are needed.
d) Do not cover or obstruct any openings in the appliance.
e) Covering the ventilation slots may cause damage to the appliance.
f) Place the microwave appliance as far away from radios of TVs to minimize any
interference to radio and TV reception.
2) Insert the power plug into a normal household outlet; check that voltage and
frequency of the appliance (see appliance rating label) matches that of the
household electrical supply.
11.5.3
The device can cause the occurrence of interference in radios, televisions
or similar devices.
Such faults can be rectified or reduced as a result of employing the
following measures:
• Clean the door and the sealing surfaces of the device.
• Set the radio, the television, etc as far as possible away from the
device.
caso HCMG 25
Installation of the appliance
Avoiding radio interference
1) Select a level surface
providing enough distance
between the ventilation
slots and walls or other
a) The surface for placing
units.
the appliance must be at
b) The rear of the appliance
least 85 cm above the
floor.
must be facing a wall.
Above the appliance a
clearance of 30 cm is
59