Caso Germany HCMG 25 Mode D'emploi page 58

11.3 Unpacking
To unpack the device, proceed as follows:
• Remove all packaging and accessories.
• Check the appliance for possible damages (dents, damaged door etc.).
Damaged appliances may not be used.
• Casing: Remove the protective film covering the outside surface of the
appliance.
• The light brown/silver cover in the interior of the appliance protects the
magnetron and must not be removed.
11.4 Disposal of the packaging
The packaging protects the device against damages during transit. The
packaging materials are selected in accordance with environmentally
compatible and recycling-related points of view and can therefore be
recycled.
Returning the packaging back to the material loop saves raw materials
and reduces the quantities of accumulated waste. Take any packaging
materials that are no longer required to "Green Dot" recycling collection
points for disposal.
► If possible, keep the original packaging for the device for the duration
of the guarantee period of the device, in order that the device can be
re-packaged properly in the event of a guarantee claim.
11.5 Setup
11.5.1
In order to ensure the safe and trouble-free operation of the device, the
setup location must fulfil the following prerequisites:
• The device must be set up on a firm, flat, horizontal and heat-resistant
surface with sufficient load-bearing capacity for the oven and the
maximum weight of the expected food that is to be prepared in the
oven.
• Choose the setup location in such a way that children cannot reach any
hot surfaces on the device.
• The device is not intended to be installed in a wall or a built-in
cupboard.
• Do not set up the device in a hot, wet or extremely damp environment
or near flammable material.
• Ensure that the power cable does not hang down over a table or
counter edge.
caso HCMG 25
Please note
Setup location requirements:
58