MIRKA DEOS CV Serie Mode D'emploi page 58

en (original)
Symptom
Brake seal does not work.
(Not applicable for DEOS 343)
The sander has stopped and LED
(right) is red.
Disposal information
58
Mirka® DEOS 343, 353, 383 & 663
Possible cause
Worn out brake seal or damaged
spindle bearing.
The tool is in safety mode due to high
temperature.
DANGER
Render redundant power tools unusable by removing the power cord.
Observe applicable country-specific regulations regarding disposal and recycling of disused machines,
packaging and accessories.
EU only: Do not dispose electric power tools in house-hold waste. According to European Directives
on waste electrical and electronic equipment and its implementation under national law, electric
tools that have reached the end of their life must be collected separately and taken to an environ-
mentally compatible recycling facility.
For more information regarding REACH, RoHS and our corporate social responsibility visit
www.mirka.com
Solution
Check and replace brake seal or
spindle bearing if necessary.
Wait until the tool has cooled down.