Güde KTP 18-0 Traduction Du Mode D'emploi D'origine page 18

ENGLISH
14
Symbols
WARNING/CAUTION!
WARNING - Read the operating instruc-
tions to reduce the risk of injury.
Remove the battery pack before starting any
work on the appliance.
Wear goggles.
Staying in the transportation medium
prohibited
Warning against dangerous voltage
Class III tool.
V
Voltage
Any damaged or disposed electric or
electronic devices must be delivered to
appropriate collection centres.
CE marking
Battery
Protect the battery against heat and fire.
Protect the battery against water and
moisture.
Protect the battery against temperatures
above 40°C.
MAX 40°C
Class II tool.
Do not throw the batteries in household
waste.
Li-Ion
Deliver the batteries to a collection centre of
old batteries where they will be recycled in
an environmentally friendly way.
Safety Instructions
Do not grab the feeder cable, plunge the pump, lift or
carry it while it is connected to the grid!
This appliance is not intended for use by persons
(including children) with limited physical, sensory or
mental capabilities or insufficient experience and/or
knowledge unless they are supervised by a person
who is responsible for their safety or have been
instructed by them in the safe use of the appliance.
Children should be supervised in order to ensure
that they do not play with the tool. Always keep
children and unauthorised persons out of reach of the
appliance.
Remove battery before submerging.
Remove battery after decommissioning, when reme-
dying faults and before maintenance.
If the pump is in operation, neither people nor animals
can be present or plunged in the pumped liquid (e.g.
pools, cellars, etc.).
The temperature of the drained liquid must not
exceed +35 °C.
The pump must not in any case run without fillings.
Never operate the pump when it is left unsupervised
in order to prevent damage caused by any possible
malfunctions. In principle, you must always remove
the battery when the pump is not in use.
If the pump is used in ponds, wells, etc. and appropri-
ate pumping stations, standards valid for pumps in
the given country must unconditionally be observed.
The user is responsible to third parties if pump (dum-
ping stations, etc.) is used.
Protect the feeder cable from excessive temperatures,
oil and sharp edges.
To avoid danger, a damaged mains supply pipe must
be replaced by the manufacturer. Do not under any
circumstances attempt any repair yourself.