EQUATION EQM 10 Manuel D'installation, D'utilisation Et D'entretien page 119

4.6 Temperature control: Manual / Automatic
Temperature control and its modification can be done manually or automatically, and can be performed by pressing key No. 6
when the display is in standby mode or in the heating phase. In this case one must press the following keys:
Key
1 Exit from user menu
2 Next function of user menu
3 Previous function of user menu
Decrease parameter
4
Increase parameter
5
6 Select function of the user menu
Example:
To enter the user menu, when the screen is on hold, press the button nº 6
until the screen confirms you that you can enter the menu.
With key 2 lower menu until the sub-menu «option», confirm with the button 6;
slide menu to the sub menu 'load' with button 2.
With key 5 load for 30 seconds, pressing the key 4 to stop the load.
IN THE FIRST STOVE IGNITION ONE SHOULD ALWAYS CHECK THAT THE PELLET COMPARTMENT IS FULL
In order to follow this operation, enter the menu use/option/load (paragraph 5.10.)
NOTE:
Flame variations depend on the type of used pellet, normal variability of solid fuel and regular fireplace cleaning.
We recommend you to make automatic cleaning before each ignition.
T.Amb
Auto
Function description
21ºC
Heat
119