EQUATION EQM 10 Manuel D'installation, D'utilisation Et D'entretien page 112

3.2 Stove preparation
Once determined the stove location, you can proceed to remove the packaging
The oven is packaged in a wooden box with a rigid plate.
Firstly:
• Remove the wooden box
• Unscrew the wooden plank in order to release the stove
• Open the door of the fireplace and take the accessories:
• Power cable, rubber feet (picture A, F)
• Remote control (picture F)
• Top lid (picture E)
• Fireplace gas deflector (picture B)
In case you need to move the stove, you should be careful not damaging vacuum engines which are placed at the button
of the stove.
Before starting the stove installation:
• Screw the rubber feet to the bottom part of the stove
• Check that the door opens and closes properly.
• Install the deflector in the fireplace (see Pictures C-D) in the inclined and build in area.
• Place the top cover.
• Plug the power wire into the outlet located at the bottom rear of the stove (picture G1)
A
D
B
E
G1
112
C
F