EQUATION EQM 10 Manuel D'installation, D'utilisation Et D'entretien page 118

ATTENTION
• DO NOT USE ANY FLAMMABLE FLUIDS DURING THE POWER ON
• DURING THE PELLET LOADING PHASE, DO NOT PUT THE PELLET BAG IN CONTACT WITH THE HOT
SURFACE OF THE STOVE
4.5 Control panel
TOUCHSCREEN
The screen utilization is made through touch screen keys. In the following you will find the use of each button:
Key Description
1
ACC
2
+ PWR
3
– PWR
4
– AIR
5
+ AIR
6
MENU
In the figure below you can see the placement of the buttons described above.
Figure 1. Screen
The screen is a touch screen. It is equipped with a LED which indicates when the stove is in operation, a LCD screen with 16
characters in two lines and a sensor for the reception of IDRA signals with an infrared remote control
Operation
Stove Turn on / Switch off.
Enter into the technical menu
and eliminate the alarm.
Increase of heating power
Decrease of heating power
Decrease of air entrance
Increase of air entrance
Enter into the menu and then
into the submenu environmental
temperature, then air
channeling
Room temperature menu
Exit environmental
temperature menu
Manual Heat
Automatic Heat
Decrease of environmental
temperature
Increase of environmental
temperature
Exit from environmental
temperature sub-menu
118
Inside the menu
Menu Exit: Without
saving the selected
parameters.
Next parameters
without saving
parameters in the menu
Previous parameters
without saving the
values in the menu.
Decrease of
parametered values
Increase of parameter
values
Save the chosen values
and go next – Enter into
the submenu
.