Retaining shaft assembly
For packing reasons, the cylinder is descended in
the lowest position.
After completing the assembly, bring the log
splitter to its working position.
To do so, start the engine, raise the cylinder to its
working position.
Press the two operation handles (6 & 9)
downwards until the cylinder raises to the top of
the machine, then insert two shafts (A) into the
holes of the machine, and lock with two R-pins
(B) to secure the cylinder on the machine.
Lifting device assembly
Assemble bracket (a) with 2 hexagonal bolts
M10*25 (b) and secure with 2 hexagonal nuts
M10.
Position tube (c) in holder (d) and insert hexagonal
bolt M10*55 (e) then fix with M10 nut (f).
Finally connect the chain to the stud on lifting
device arm and on wedge sliding assembly.
4.3- Set up and preparation for operation
- Check that the machine is completely and correctly assembled according to local regulations.
- Make sure that no parts are missing. If one (or more) part(s) is (are) missing, do NOT use the splitter.
Contact your local dealer to obtain the missing parts and make sure to correctly assemble them before
using the machine. Failure to do so may result in serious injury.
- Before using the machine, make sure each time that
there are no faulty connections (tears, cuts, etc.)
there is no damage to the machine
all screws are tight
check the hydraulic system for any possible leaks, refill oil if necessary
- Ensure that the working area meets the following conditions:
Flat levelled surface and strong enough to support the weight of the machine.
no danger of slipping
free of obstacles
sufficiently well lit
- Do not operate the machine in the direct vicinity of gas or petrol pipes or containers, or any other
easily inflammable or explosive materials.
- Proceed to following functional test prior to each use:
Check oil level before each use!
Action
Press both handles down
Press return bracket downwards or both
handles upwards
Release the two handles
Result
The splitting knife (wedge) goes down to
approx. 18cm above the table base.
The splitting knife (wedge) moves to the
upper position.
The splitting knife (wedge) remains in
the selected position.
Page 33 / 34