afx light BEAM100-LED Manuel D'utilisation page 6

Function No.(V)
Reset Calibration
Sensor Monitor
System Error
DMX Monitor
Error
MT board connection failed
Pan Reset failed
Tilt Reset failed
Pan Hall failed
Tilt Hall failed
Color Wheel Reset failed
Gobo Wheel Reset failed
Focus Reset failed
EN 6
Description
Pan Calibration
Tilt Calibration
Color Calibration
Gobo Calibration
Focus Calibration
Prism1 Calibration
Prism2 Calibration
Rainbow Calibration
Frost Calibration
Pan Hall
Tilt Hall
Color Hall
Gobo Hall
Focus Hall
Prism1 Hall
Prism2 Hall
Panwheel State
Tiltwheel State
Panwheel Step
Tiltwheel Step
(See common mis-
takes)
Description
The driver board did not respond. Serial communication line
connecting display panel and driver board
There is a problem, or there is a problem with the driver
board.
X-axis photoelectric switch, or problem with X-axis motor
Y-axis photoelectric switch, or problem with Y-axis motor
Pan Hall have problem
Tilt Hall have problem
Color Wheel Hall, or Color Wheel motor have problem
Gobo Wheel Hall, or Gobo Wheel motor have problem
Focus Hall, or Focus motor have problem
After entering the sub-interface, you can adjust the
motor such as X-axis and Y-axis.
Reset position to compensate for errors in hardware
installation.
Adjustment range -128~+127. +0 means no adjust-
ment.
0 when magnetic is detected, otherwise 1
2 digits, each corresponding to a photoelectric switch
in the encoder disc
Towards the positive direction, the step value should
increase. Towards the negative direction, the step va-
lue should be reduced. The value is the same every
time you go to a certain point
If the red ERR indicator is lit, the luminaire is running.
After viewing, you can press the "Clear" button to clear
the error record.
This enters the sub-interface and displays the channel
values.
© Copyright LOTRONIC 2019