Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
AFTER USING THE MACHINE
After working, before leaving the machine:
1.
Empty the tanks (23 and 22) as shown in the previous
paragraph.
2.
Perform the daily maintenance procedures (see the
Maintenance chapter).
3.
Store the machine in a clean and dry place, with the brush/
pad-holder and the squeegee blades lifted or removed.
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days,
proceed as follows:
1.
Perform the procedures shown in After Using the Machine
paragraph.
2.
Open the cover (4) and disconnect the battery connector
(7).
3.
Store the machine in a clean and dry place.
4.
To safeguard the brush or squeegee blades, turn the
handlebar (1) forward and park the machine as shown in
fi gure 4.
FIRST PERIOD OF USE
After the fi rst 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrity
and leakage.
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. The following chart
provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be
defi ned by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed with the machine switched off and the battery/battery charger cable
disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Center. This Manual describes only the easier and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Squeegee cleaning
Brush cleaning
Tank and vacuum grid cleaning
Squeegee blade check and/or replacement
Battery charging
Screw and nut tightening check
Brush deck rubber pad check and/or replacement
Brush deck end-of-stroke cable check and/or replacement
Brush deck rubber fl ange check and/or replacement
(1)
And after the fi rst 8 working hours.
(2)
For the relevant procedure, refer to the Service Manual.
14
USER MANUAL
9098868000(1)2010-11 A
Daily, after using
the machine
SC350
Figure 4
Every six
Weekly
months
(1)
P100410
Yearly
(2)
(2)
(2)
Publicité
