Publicité
Les langues disponibles
Les langues disponibles
WARNING! Risk from batteries
Protect the battery against mechanical damages. Fire hazard!
Do not expose the appliance to direct sunshine or heat. The ambient temper-
ature should not be lower than 0 °C or higher than +40 °C.
The charge contacts on the appliance must not be connected by metallic
objects.
Charge the appliance's built-in battery exclusively using the original acces-
sory parts.
The appliance must only be operated with the original
supply unit.
If the electrolyte solution leaks out of the battery, avoid contact with eyes,
mucous membranes and skin. Rinse immediately with plenty of clean water
and consult a doctor. The electrolyte solution can cause irritation.
The appliance contains a lithium ion battery.
– This appliance must not be opened!
WARNING! Risk of injury from cutting
Do not use the appliance with a damaged or fractured cutter head.
The cutter head must not be disassembled.
While the appliance is switched on, do not touch the cutter head.
The appliance must be switched off:
– when mounting or removing an attachment comb.
– when you put down the appliance, e.g. when you interrupt the cutting pro-
cess briefly.
– before removing or mounting the cutter head.
18
ENGLISH
– before cleaning the appliance.
Use only the original attachment combs.
Do not use a damaged attachment comb.
ATTENTION! Risk of material damage
The cutter head is a precision part. Protect it against damage.
In order to avoid increased wear of the cutter head and motor, the cutter head
must be cleaned and oiled regularly (see "Cleaning and care" on page 21).
Do not clean using sharp objects or abrasive cleaning agents.
The battery charger is fitted with non-slip plastic feet. As furniture is coated
with a wide array of varnishes and synthetics, and is also treated with differ-
C20 power
ent care products, it cannot be fully ruled out that some of these materials
contain components that could attack and soften the non-slip plastic feet. If
necessary, place a non-slip mat under the appliance.
Protect the appliance against heat (e.g. direct sunlight), chemical substances
(e.g. perm agents) and mechanical damage (e.g. by dropping).
Specifications according to Machinery Directive 2006/42/EC
A-weighted emission sound pressure level at workstations at a distance of
pA
1 m, L
≤ 70 dBA
measured maximum noise emission value, including uncertainty of measure-
ment according to EN ISO 4871. Determination of the values according to
EN 60704-2-9 with reference to EN 60704-1
Vibration total value to which the hand-arm system is subjected,
2
a h < 3.96 m/s
measured maximum vibration total value including uncertainty of measurement.
Determination of the values according to EN ISO 5349-1/2
Publicité
