Changing From 'Manual Fill'to 'Plumbed - FLAVIA Creation 200 Manuel D'utilisation

CHANGING FROM 'MANUAL FILL'TO 'PLUMBED'

MAKE SURE YOUR APPLIANCE IS SWITCHED OFF.
Step 1
Make sure that the water reservoir has been drained. See section headed DRAINING THE COLD
WATER RESERVOIR.
Step 4
Replace the FLAVIA badge.
Step 2
Remove the FLAVIA badge from the right hand
side of the Brewer.
Step 5
At the rear of the Brewer remove the protective cap from 'mains
water inlet' and connect to the water supply using the
recommended inlet hose.
Refer to the 'Plumbed Systems' instructions under INSTALLATION
OF YOUR FLAVIA® BREWER (page 17).
Step 6
Turn on the water supply, and ensure that all connections are
watertight.
Step 7
Turn on the mains electricity supply
14
Step 3
Pull the red rubber switch towards
you and replace. This will reset the
overflow switch enabling a plumbed
water supply to be connected.