How To Use - FLAVIA SB100 Guide Utilisateur

How to use

Water supply light
• Water level in the tank is low
Please add water
Drink settings lights
• How to choose between the settings
Espresso type
For a stronger flavour and for ice drinks
• Volume of water extracted: approx. 120ml
Regular coffee/Standard leaf tea
• Volume of water extracted: approx. 165ml
Instant drink
• Volume of water extracted: approx. 145ml
Note: The volume of water extracted is pre-set.
The volume will vary depending on the type of drink
and drink filterpacks.
How to heat water
1
Fill the tank with water.
Water
heated
2
in the
Plug in the appliance and
separator.
*Approx.
turn the power switch on.
3 minutes
Water
tank
* A p p rox .
2 5
m i n u te s
Keep warm mode
* At a room temperature of 20˚ C and a full tank.
How to make a drink
Place a cup inthe cup stand
• Recommended cup size to be used with the
appliance is 72mm in diameter and 92mm in height.
Notice • Smaller cups and those with a rounded
bottom can cause splashing when a
beverage is dispensed.
• Only use cups suitable for hot drinks.
• Do not use plastic vending cups.
Select the setting depending
Towards Towards
on the drink you want
The setting will automatically
return to after 30 seconds.
Make your selection again.
• Never use any other setting
but the with instant drink
filterpacks.
The light under the
Notice
On the a n d settings,
selected setting will
come on. an instant drink filterpack may burst .
Press the start button.
Open the filterpack h o l d e r
Place the filterpack in the
filterpack holder
Approximately 15 seconds after
closing the filterpack holder, the
' R e m o v e-filterpack' light will come on.
Water heating light
• Water is heating
Remove filterpack
Please wait
light
• This light will come
on when a used
filterpack is left in
the appliance after
making a drink
Please remove the
filterpack
Comes on automatically
when water tank starts
operation.
Time required to make
Red light
the first drink is
approximately
3 minutes. Another cup
can be made as soon as
the green light comes on.
If a drink is made
Green light
immediately after adding
water to the tank, the
water may not be
sufficiently hot.
Press the start button to open the
filterpack holder, re-select your
p r e f e r r e d drink setting and close the
filterpack holder.
Press the start
button to
Start Operation
Completing your drink
When the Remove-filterpack light comes on
Remove cup
Caution
Do not press the start button during brewing.
• For instant drinks, please stir to fully
Notice
dissolve before drinking.
After the drink is dispensed
Open the filterpack holder and
remove the used filterpack.
• The filterpack will be hot. Ta ke ca re when
Notice
re m oving it.
• A f ter the drink is dispensed, the used filterpack must
be re m oved (if the filterpack is not re m oved, the drink
making function and hot water dispensing function will
not opera te ) .
When the filterpack is re m ove d C lose the filterpack
holder and lower the start button into its original position.
5
M a i n te n a n ce
With use, scale deposits will form on the internal surfaces.
These need to be removed once in every two months.
Mesh filter and separator should be cleaned
by
Light on
dipping in water and agitating.
• Do not use washing up liquid or bleach
(If this does not prove effective please
use a suitable brush).
Light on
Light on
Storage
Storage: When you are not using the appliance for a period of time
1
Check that there is no filterpack left in the filterpack holder
2
Switch the power switch off and pull the plug out of the socket
3
Detach the drip tray and remove any water contained in it
4
R e m ove the lid and dispose of unused heated water (for the co r rect way to dispose of unused water please see page 4)
Weekly maintenance
Wipe the dust off the casing and the lid with a well-wrung wet cloth.
• Do not wash with water.
(Water may get into the internal electrical parts resulting in malfunction.)
• Do not use cleaning agents.
(They may leave traces.)
• Do not apply any products containing benzene to the appliance.
(This may damage the surface of the appliance.)
Wipe the walls of the tank with a wet cloth.
• Do not clean with brushes or scouring agents. (This may damage the surfaces.)
Filterpack holder, drip tray and cup stand should be washed with a wet cloth.
How to remove
Remove the drip tray.
Open the filterpack holder and push down firmly until fully open.
Push down again and pull out directly downwards.
How to replace
Pins
Insert the bottom end of the filterpack holder by pushing
diagonally upwards until secured with the left and right pins on
the body.
Close the filterpack holder.
* When the filterpack holder is put into position you will hear a loud
click.
Bi-monthly maintenance
If you observe change of colour due to scale or a
floating layer in the tank and mesh filter.
Minerals contained in the water may form deposits on the
surfaces with which water comes in contact. This is not
corrosion of the tank itself, nor is the change in colour a
change on the tank itself. The deposits are not harmful.
This may take the form of:
• Change of co lour to milky white, brown or dark grey.
• Rough surfaces or spots of rust.
• White or shiny layer due to mineral crystallisation.
Notice
• Do not put in a dishwasher or dryer of any kind.
( T h i s may result in the casing becoming defo r m e d . )
• When storing:
- Dry we l l .
- P ro tect from any objects getting into the appliance by
w rapping in plast i c .
6