Olimpia splendid OS-KEAPH12EI Mode D'emploi Et D'entretien page 74

Malfunctioning
The unit will not start.
The unit does not cool or heat
the room well (only for cooling/
heating models), while air
escapes from the conditioner.
If the problem has not been solved, contact the local dealer or nearest after-sales assistance service. Provide
detailed information regarding malfunctioning and the unit model.
5 - TECHNICAL DATA
For the technical data listed below, consult the characteristic data plate affixed to the product.
• Power supply voltage
• Maximum power absorbed
• Maximum current absorbed
Model
Dimensions (mm)
(Width x Height x Depth)
Weight (kg)
(without packaging)
Operating limit conditions
• Maximum operating temperatures in cooling mode
• Minimum operating temperatures in cooling mode
• Maximum operating temperatures in heating mode
• Minimum operating temperatures in heating mode
• Wiring diagram
EN - 30
Cause
Current failure
The unit is disconnected from the
current.
A fuse has blown.
The remote control batteries may be
discharged.
The time set with the timer may not
be correct.
Incorrect temperature setting.
The air filter is clogged.
The doors or windows are open.
The air inlet or outlet vents of the
indoor or outdoor units are blocked.
The compressor 3 minute protection
has activated.
• Cooling capacity
• Refrigerant gas
720 x 495 x 270 805 x 554 x 330 890 x 673 x 342
What must be done?
Wait for the current to be restored.
Check that the plug is inserted in the
wall socket.
Replace the fuse.
Replace the batteries.
Wait or annul the timer setting.
Set the temperature correctly. Consul
the "Using the remote control" chapter
for the procedure.
Clean the air filter.
Close the doors or windows.
First, remove the obstructions and
then re-start the unit.
Wait.
• Protection rating of the
casings
• Max. operating pressure
10C - 12C 18C
7,6 Kg 10 Kg
internal DB 32°C
external DB 43°C
internal DB 17°C
external DB -15°C
internal DB 30°C
external DB 30°C
internal DB 0°C
external DB -15°C
figure 48
24C
12,3 Kg