Olimpia splendid OS-KEAPH12EI Mode D'emploi Et D'entretien page 70

3.7.3 - Setting combined timer
(Simultaneous setting of the ON and OFF timers)
TIMER OFF > TIMER ON (figures 33, 34 and 39)
(On => Stop => Start functioning)
This function is useful if the air conditioner is to be switched off after going to bed and switched back on in
the morning or when returning home.
Example:
The time is 20:00. If the air conditioner is to be switched off at 23:00 and switched back on at 06:00.
a. Press the "TIMER OFF" key (8) to display "TIMER OFF".
the time flashes.
b. Press the "TEMP" keys (4) until the value "3:00" is set near to the "TIMER OFF" indicator.
c. Press the "TIMER ON" key (7) to display "TIMER ON".
the time flashes.
d. Press the "TEMP" keys (4) until the value "10:00" is set near to the "TIMER ON" indicator.
e. Wait 3 seconds, the time set will stop flashing and the function will be active.
TIMER ON > TIMER OFF (figures "33", "34" and "40")
(On => Stop => Start functioning)
This function is useful if the air conditioner is to be switched on before getting up and switched off after
leaving home.
Example:
The time is 20:00. If the air conditioner is to be switched on at 06:00 the next morning and switched of at 08:00.
a. Press the "TIMER ON" key (7) to display "TIMER ON".
the time flashes.
b. Press the "TEMP" keys (4) until the value "10:00" is set near to the "TIMER ON" indicator.
c. Press the "TIMER OFF" key (8) to display "TIMER OFF".
the time flashes.
d. Press the "TEMP" keys (4) until the value "12:00" is set near to the "TIMER OFF" indicator.
e. Wait 3 seconds, the time set will stop flashing and the function will be active.
3.8 - MANUAL OPERATION
Manual operation can be used temporarily if the remote control cannot be found or its batteries are discharged.
a. Open and lift the front panel to an angle in which it blocks and a "click" is heard (figure 41).
b. Press the control key once (AUTO/COOL) to start operation in "AUTO" mode (figure 42).
c. Close the panel well, taking it back to its original position (figure 46).
• By pressing the manual key, the operating passes in sequence to:
AUTO > COOL > OFF.
• Press the key twice to start the unit in forced "COOL" mode.
This mode must be used for the inspection only.
• By pressing the key a third time. operation stops and the air conditioner switches off.
• To restore remote control operation, use the remote control directly.
4 - MAINTENANCE AND CLEANING
Before proceeding with any maintenance and cleaning, always make sure the system
has been switched off, using the remote control, and the power supply plug has been
disconnected from the system socket (or the upstream master isolating switch is
positioned at "0" OFF).
EN - 26
(figures 41 and 42)