Olimpia splendid OS-KEAPH12EI Mode D'emploi Et D'entretien page 63

BEFORE MAKING THE ELECTRIC CONNECTION, MAKE SURE THAT THE UPSTREAM
ISOLATING SWITCH IS AT "0" (OFF) AND THE PROTECTIONS OF THE INDOOR AND
OUTDOOR UNITS ARE POSITIONED CORRECTLY.
d. Connect the power supply cable terminals (32) (not supplied) to the terminal board (28) positioned in
the outdoor unit electric connections compartment.
e. Before re-installing the protection of the electric connections, fix the power supply cable via the relevant
cable tie (31), positioned in proximity of the outdoor unit terminal board (28).
2.7.5 - Delivery of the system
When all checks and controls regarding the correct operation of the plant have been completed, the installation
technician must illustrate the following to the purchaser:
- the basic operational features,
- the plant switch-on and switch-off instructions,
- the normal use of the remote control,
- the first practical advice for routine maintenance and cleaning.
3 - USE AND MAINTENANCE
3.1 - USE OF THE REMOTE CONTROL
The remote control supplied with the air-conditioner is the
instrument that enables you to use the appliance in the most
convenient way.
It should be handled with care and in particular:
• Keep it dry (do not clean it with water or leave it outdoors in
bad weather).
• Avoid dropping or bumping it.
• Keep it out of direct sunlight.
• The remote control operates by means of an infrared beam.
• During use, there must not be any obstacle between the remote control and the air-conditioner.
• If other appliances in the room have remote controls (TV, stereo, etc...), there may be interference.
• Electronic and fluorescent lights may also interfere with transmissions between remote control
and air-conditioner.
• Remove the batteries in case of prolonged disuse of the remote control.
3.1.1 - Insertion of batteries
The remote control is not supplied with batteries.
To insert the batteries correctly (figure 31):
a. Remove the batteries compartment cover.
b. Insert the batteries into the relevant compartment.
Check the polarity indicated on the bottom of the compartment .
c. Close the compartment correctly.
3.1.2 - Replacement of batteries
The batteries should be replaced when the display on the remote control does not appear sharply or when
the remote control does not change the settings.
Always use new batteries and replace both at the same time.
The use of old or different batteries could generate malfunctioning of the remote control.
ARYAL S1 E INVERTER 10-12-18-24 C
EN - 19