C. THE HELMET
Fitting
1. Remove the visor from the helmet.
2. Use the notch to help position one side of the
anti-fog lens on one of the eccentric holding
pins. Make sure that the silicone seal is facing
the visor.
3. Carefully bend the visor just enough that
the notch is guided onto the other eccentric
holding pin on the opposite side of the anti-fog
lens. To do this, you will need to bend the end
of the anti-fog lens into a slight S-shape.
4. Checking the correct application of the
anti-fog lens, by trying to slide a piece of
paper between the visor and the anti-fog
lens. In case it gets between the two,
please follow point 5.
5. In case of needs, it is possible to regulate
the pressure on the seal by adjusting the
eccentric locking-pins. To do so, remove
the anti-fog lens, then use a flat object
with no sharp-edges to push the locking
pins out of the face shield carefully from
the inside; then rotate them by 180° and
reinsert them. Fit the anti-fog lens and
check the seal.
22