Christopeit Sport EL8000 Instructions De Montage Et D'utilisation page 18

STEP 3
Installation of the handgrip (16) and foot rest holder (42)
at connecting tubes (27).
1. Push the handgrip bars (16L+16R) onto the connecting
tubes (27L+27R) and adjust the holes in the tubes so that they
are aligned. (Note: The handgrip bars must be aligned after
assembly so that the upper ends are inclined outwards (away
from the support (13)). Further the connection tubes (27) must
be arched to front side).
2. Push the bolt M8x45 (25) through the holes and tighten the
hand grips (16) with nylon nuts M8 (26) rmly. Take care that
the nuts have right positon at hexagonal hole.
3. Push the footrest holder (42R) at the connecting tube (27R)
and adjust the holes in the tubes so that they are aligned.
4. Push the Screw M10x78 (35) through the holes and tighten
the footrest holder (42R) at connection tube (27R) with washers
10//20 (38) and nut M10 (37). (This connection point has to
move easily. So please don't tighten the screw too much.)
5. Install the left footrest holder (42L) incl. all additionally
required parts on the left hand side of the machine as described
in 3.- 4.
6. Place the preassembled unit of the right footrest holder
(42R) and connecting tube (27R) at the right hand side of the
main frame (52). (Note: Right is specied as viewed standing
on the machine during training.)
7. Push onto the axle of support (13) one wave washer (11)
and the right hand grip (16R). Put on the screw M8x20 (20)
a spring washer (21) and a washer 8//24 (22) and tighten it
rmly.
8. Put the right foot rest holder (42R) and a distance ring (48)
at the pedal crank (81) and tighten them with washer 8//24
(22), spring washer (21) and screw (20) rmly.
9. Install the left footrest holder (42L) incl. all additionally
required parts on the left hand side of the machine as described
in 6.- 8.
10. Put the plugs of pulse cable (18) and pulse connection
cable (10) together.
STEP 4
Installation o the dierent covers (9, 24, 34+44).
1. Remove the screws (45) from rear end of foot rest holder
(42) and use it to mount the foot pedal cover (44) to both side
rear end of foot rest holder (42).
2. Remove the screws (7) from bottom of front end of foot
rest holder (42) and the screws (33) from front foot rest covers
(34R). Use them to mount the plastic cover set (34L+34R) to
both side front end of foot rest holder (42).
3. Remove the screws (8) from hand grip covers (24) and
use them to mount the hand grip covers sets (24La+24Lb) and
(24Ra+24Rb) to the handgrips (16).
4. Remove the screws (7) from support (13) and screws
(8) from bottle rack (9b). Use them to mount the bottle rack
(9a+9b) at support (13).
90
20
21
42L
52
89
24Lb
24La
9a
7
42L
44
52
45
18
16L
18
10
13
22
27L
11
25
37 38
81
21
20
48
22
16L
13 16R
27L
34L
27R
42R
44
GB
16R
26
27R
35
42R
9b
8
24Rb
8
24Ra
33
34R
7