Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Remove all the separate parts from the packaging, lay
them on the oor and check roughly that all are there
on the base of the assembly steps. Please note that
a number of parts are connected directly to the main
frame preassembled. In addition, there are several other
individual parts that have been attached to separate units.
This will makes assembly easier and quicker for you.
Assembly time: 70 min.
STEP 1
Attach the stabilizer (49+69) at main frame (52).
1. Remove the protection material from front and rear side of
main frame (52).
2. Attach the front foot (49) with the preassembled transport
rollers (50) to the main frame (52). Do this with the two screws
M8x45 (70), washers 8//19 (29), spring washers (21) and cap
nuts M8 (51).
3. Attach the rear foot (69) to the main frame (52). Do this
with the two screws (70), washers (29), spring washers (21)
and cap nuts (51). After assembly has been completed, you
can compensate or minor irregularities in the oor by turning
the wheel at cap (68). The equipment should be set up that the
equipment does not move of its own accord during a training
session.
STEP 2
Assembling of support (13) at the main frame (52).
1. Place screws M8x20 (28), washers 8//19 (29) and spring
washers (21) accessibly beside the front part of the main
frame (52).
2. Place at lower end of the support (13) the plastic cover (60)
with rubber ring (59) and lay it on the oor. Place the lower
end of support (13) against the holder at main frame (52)
and plug the ends of the two cables (30+31) projecting from
(13+52) together. (Attention! The computer cable harness
(30) projecting from the support (13) must not slide into the
tube, as it is required for later steps of installation.) Then push
the support (13) onto the main frame (52). When joining the
tubes, ensure that the cable connection will not trapped.
3. Put one spring washer (21) and one washer (29) on
each screw (28). Push the screws (28) through the holes in
the support (13), screw into the threaded holes of the main
frame (52) and tighten it. Then place the plastic cover (60)
with the rubber ring (59) in the correct position over the screw
connection.
90
69
68
70
89
17
50L
49
52
51
21
29
13
59
29
28
60
21
31
30
52
GB
51
21
29
50R
70
Publicité
