Accessories, Tools - Festool DOMINO DF 500 Guide D'utilisation

23a.1
– Take two pieces of scrap wood, and draw a
thin line on each piece where a tenon is to be
placed.
– Set the mortise slot width to the narrow setting
(see "Setting the mortise width").
– With the middle line [23a.2] of the sight gauge
lined up on the pencil line, plunge a mortise slot
into each piece of wood.
– Join the two pieces of wood together without
glue, and examine the alignment of the original
pencil lines.
– If the pencil lines are not aligned, loosen the two
screws [23a.1] on the sight gauge and slide the
gauge sideways as noted in the upper image.

Accessories, Tools

For your own safety, use only original
Festool accessories and spare parts.
The accessory and tool order number can be found
in the Festool catalogue or on the Internet under
www.festoolusa.com.
Systainer
Many Festool products are shipped in a unique
system container, called "Systainer". This provides
protection and storage for the tool and accessories.
The Systainers are stackable and can be interlocked
together. They also can be interlocked atop Festool
CT dust extractors.
– To open the Systainer:
• Turn the T-loc [23.1] to the position
– To lock the Systainer:
• Turn the T-loc [23.1] to the position
To connect two Systainers:
• Place one Systainer on the top of the other
(Fig. 23 A).
• Turn the T-loc [23.1] to the position
(Fig. 23 B).
The Systainers are connected and locked.
23a.2
A
B
23.1
 A new generation Systainer is connectable on
top of a previous generation Systainer by the four
latches of the previous Systainer.
.
.
17
or
23