Publicité
Les langues disponibles
Les langues disponibles
Remark:
* Use a ring tongue terminal in
order to connect a ground
wire to terminal.
NOTE
All wiring must conform to national, state/provincial and local codes.
Step 1: Remove the desired knockout on the control box.
Step 2: Attach a conduit pipe connector to the control box and route the wiring as shown in the above
diagram. Ensure that the conduit connection hole is airtight; add a sealant if necessary.
Step 3: Firmly tighten all of the terminal screws. After tightening, verify that the wires are tightly fastened.
Specifications are subject to change without notice.
PAA-A18, 24, 30, 36, 42AA1/BA1/CA1
Grounding Terminal*
75
PAA Control Box
Grounding
terminal*
Disconnect
switch
(if required)
Grounding Terminal*
© 2022 Mitsubishi Electric US, Inc.
Publicité
