Mitsubishi Electric PAA-A18AA1 Manuel D'installation page 51

Step 1: Remove and discard (recycle) the top left Z‑bracket. Remove the 2 triangular pieces from the heat
exchanger assembly.
CAUTION
When moving from
right to left install
position, the front
triangular piece,
distinguishable with a
V–notch on one edge,
remains in front of the
heat exchanger
assembly and the
back triangular piece
remains at the back
of the assembly.
Failure to do so can
result in condensate
drainage problems.
Step 2: Attach the 2 triangular pieces to the left hand side of the heat exchanger assembly.
Specifications are subject to change without notice.
PAA-A18, 24, 30, 36, 42AA1/BA1/CA1
51 © 2022 Mitsubishi Electric US, Inc.