IKRA GMTI 52 Gardol Manuel D'utilisation page 75

Adjusting the carry strap
3
The design and type of carry strap may vary.
• Put on the shoulder strap (1).
• Adjust the length of the belt so that the spring hook (2)
is roughly a hand's width below your right hip.
PLEASE NOTE: This carry strap has a safety
device allowing you to immediately disconnect the
strap from the machine in an emergency. To do so,
pull forcefully on the red pull tab (3) on the strap.
This disconnects the strap from the holding fixture
immediately.
NOTE: Never start the motor with the carry strap
attached to the machine!
The Machine
Do not use your power scythe attachment during other
people's rest periods.
Preparations
Always wear a harness.
• Vertical cut (with straight cutter bar)
Large working radius even without additional aids
• Vertical cut (with angled cutter bar)
Cutting without standing directly next to hedge
GB-30