TLV JH-X Série Manuel D'utilisation page 11

Disassembly/Reassembly (to reassemble, follow procedures in reverse)
Part & No. JH3X JH5RL-X JH7RL-X JH7.2R-X
Cover Bolt 10
Cover Nut 11
Cover 2
Cover Gasket 3
Connector 12
Connector
Gasket 13
Drain Plug 21
*
Drain Plug
*
Gasket 22
X-element
Case 27
X-element Case
Gasket 30
Snap Ring 25
X-element
Screen 28
Spring Clip 17
(X-element)
X-element 14
Air Vent Valve
Seat 16
X-element
Guide 15
Screen 9 &
Float Cover 20
Snap Ring 24
Screen 9
Screen Holder
Retainer 26
Screen Holder 23
Float 4
Orifice Plug 7
Outlet Cover Nut 32
Outlet Cover 7
Plug or Outlet
Cover Gasket 8
Orifice 5
Orifice Gasket 6
* Option
** The entire unit may be removed and replaced at the X-element guide 15 with an open wrench.
*** Must remove X-element Case 27 before this part can be removed or inserted
JH7.5R-X JH8R-X
Use a wrench to
remove
Lift up and off (use all
four eyebolts for
JH8R-X)
Remove gasket and
clean sealing surfaces
Remove the connector
Remove gasket and
clean sealing surfaces
Use a wrench to
*
remove
Remove gasket and
*
clean sealing surfaces
Use a wrench to
** **
remove
Remove gasket and
** **
clean sealing surfaces
** ** Use appropriate pliers
Remove screen
** **
Use appropriate pliers,
** **
squeeze and remove
Remove from the guide
** **
or case
Use a wrench to
remove
Remove without
bending
Lift straight up
while turning
*** ***
Use appropriate pliers
*** ***
Lift straight up
*** ***
Remove without
*** ***
bending
Remove, being careful
*** *** not to scratch its
polished surface
Use a wrench to
remove
Remove
Remove gasket and
clean sealing surfaces
Use a wrench to
remove
Remove gasket and
clean sealing surfaces
̶ 10 ̶
Disassembly
Coat threads with anti-seize
and tighten to the proper torque
Align the cover with the
connector or the arrow on the
body and attach
Replace with a new gasket, do
not apply anti-seize
Insert the connector
Replace with a new gasket, do
not apply anti-seize
Coat threads with anti-seize
and tighten to the proper torque
Replace with a new gasket,
coat surfaces with anti-seize
Coat threads with anti-seize
and tighten to the proper torque
Replace with a new gasket,
coat surfaces with anti-seize
Insert securely into groove
Insert screen securely
Squeeze and insert securely
into the groove
Make sure the X-element is not
upside down
Coat threads with anti-seize and
tighten to the proper torque
Fix with Air Vent Valve Seat
Align arrows and insert, insert
tab on bottom into guide on
body and push in until top is
flush
Insert securely into groove
Place screen holder on ledge
inside body, round side up;
place screen holder retainer
next (if applicable), followed by
screen
Insert into body, being careful
not to scratch its polished
surface
Coat threads with anti-seize and
tighten to the proper torque
Attach
Replace with a new gasket,
coat surfaces with anti-seize
Coat threads with anti-seize and
tighten to the proper torque
Replace with a new gasket,
coat surfaces with anti-seize
Reassembly