Publicité
Les langues disponibles
Les langues disponibles
•
N: This refrigerating appliance is intended to be used at ambient temperatures ranging from
16 °C to 32 °C
•
ST: This refrigerating appliance is intended to be used at ambient temperatures ranging from
16 °C to 38 °C
Avoid placing your device near a heat source, for example, stove, boiler or radiator. Avoid direct
exposure to sunlight. Make sure that the appliance is not placed near humidity (tumble dryer for
example) to avoid the formation of condensation on the walls. Never place the appliance in a wall
or built into built-in cabinets or furniture. When your appliance is running, the grill on the back
may become hot and the sides hot. Therefore, it should be installed with an empty space of 10 cm
at the back, 10 cm at the sides, and 20 cm above.
Leveling the appliance
If your appliance is not leveled, the door and magnetic seal alignment will be
affected and may cause a malfunction. Once the appliance is placed in its final
location, adjust the leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate of soda. Then rinse with warm
water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry
completely before replacing them.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the appliance.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE APPLIANCE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes
before switching back on to allow the coolant fluid to settle.
Before filling your appliance
Before storing foods in your appliance, turn it on and wait for 24 hours, to make sure it is working
properly and to allow it to reach the correct temperature.
Reverse door
Depending on your needs, you can change the opening side of the door. You can choose to open it
from the right or from the left. To change the opening side, follow the instructions.
Warning:
•
It is recommended that you call your local authorized service agent to make this conversion
or ask technician.
•
It is recommended to use a crosshead screwdriver and a spanner (both not supplied).
•
Before changing the opening side of the door, unplug the device from the mains.
•
Any removed part must be kept until the end of installation.
•
Do not lay the device down on the floor, you could damage the cooling system.
24
Publicité
