Storage; Warranty Certificate - Maruyama MCV5100 Manuel D'instructions

GB ENGLISH
If the chain is not sharp, a bigger physical effort is required
to obtain low-quality cutting.
The chain teeth are sharpened to a 30° angle which is
suitable for the most common wood types.
This angle should be maintained until the chain has
become worn out.
Always keep the file at right angles to the teeth and file in
one direction.
Follow all the maintenance instructions previously described.
- Clean the chain saw completely and lubrificate the metallic
parts.
- Empty fuel tank and run engine until dry. Store the chain saw
in a dry place.
- Remove the spark plug, put a small amount of oil into the
These chain saw have been designed and produced with the most advanced technology. The manufacturer
guarantees its products for 24 months from the date of purchase, with the exception of product for continuous
professional service, used for third parties witch are guaranteed for 12 months from the date of purchase.
LIMITED WARRANTY
1 ) Warranty starts on the date of purchase, the manufacturer will supply free of charge any part defective in
materials and workmanship. Warranty does not provide for the replacement of the machine.
2) Product failures will be scheduled and repaired according to the normal work flow; any possible delay cannot
lead to damages nor to an extension of the warranty period.
3) Claims under warranty will be accepted on submission to your Authorized Service Dealer of the completed and
duly stamped. Warranty Certificate together with the original purchase document stating the date of purchase.
4) Warranty fails in case of:
- evident lack of maintenance;
- incorrect use of the machine or tampering;
- use of incorrect fuel and or lubricants;
- use of non-genuine parts;
- repairs made by unauthorized service people.
5) Parts subject to wear and tear such as cutting items, clutch or cutting safety devices filters, clutch etc., are not
covered by guarantee.
6) Claims for damages incurred during transportation have to be immediately reported to the carrier: failure to do
so will invalidate the warranty.
7) Should any failure occur during or after the warranty period, customer has not the right to interrupt payment nor
to a price discount.
8)The manufactorer is not responsible for any direct or indirect damage caused to persons or things by failures of
the machine or by a forced suspension in its use.
M O D . MCV5100
S.N. n.° BOUGHT BY MR.:
30
After having sharpened all the teeth, check and adjust the
cutting depht.
New chains are preset for a cutting depth of 0.65
mmwhich can be increased to 0.75 mm to cut soft wood.
If one tooth needs replacement, the new tooth must be
sharpened to the same height as the other teeth.

STORAGE

cylinder rotate the crankshaft several times using the starting
in order to distribute the oil,put the spark plug back in.
ATTENTION: all maintenance operations not reported in this
manual must be carried out by an authorized service center.

WARRANTY CERTIFICATE

MCV5600
MCV6200
DEALER: