Graef CM 820 Mode D'emploi page 16

GRINDING COFFEE DIRECTLY INTO THE FILTER HOLDER
•
Use the large or the small filter holder retainer as requested.
•
Open the outlet of the coffee bean container by using the sliding closure.
•
Set requested grinding degree.
•
Hold the filter holder between the filter holder retainer.
•
Set the switch to "AUTO".
•
Press the filter holder against the contact switch between the filter holder retai-
ner. The grinding process will start automatically.
•
As soon as the filter holder is sufficiently filled, pull it back. The grinding process
will stop automatically.
CLEANING
Old coffee remaining in the unit may lead to oxidation. This affects the result of
the preparation; unpleasant and unpalatable taste may develop. The unit should
always be in a well-kept condition in order to ensure perfect Espresso at all times.
Depending on use, clean the unit at least once a week.
Before cleaning, remove the power plug.
•
Use a soft and moist cloth to clean the outer surfaces of the unit. Use a mild
detergent in case of heavy soiling.
•
Remove the coffee bean container; hold the grinding ring; press the bean con-
tainer down and turn counter-clockwise.
•
Place the unused beans in an airtight container so keep the flavour.
•
Clean the coffee bean container and the coffee grounds container in warm wa-
ter using a little washing-up liquid.
•
Afterwards, dry the containers well.
CLEANING THE GRINDING MECHANISM
•
Remove the power plug.
•
Remove the coffee bean container as described in the chapter titled "Cleaning"
•
Turn the grinding ring to the right as far as possible.
•
Press the "PUSH" button, and continue to the grinding ring to the right.
•
When the two arrows point at each other exactly, you can remove the grinding
ring together with the upper grinding mechanism. Remove the upper grinding
mechanism from the grinding ring.
•
Clean the lower and upper grinding mechanism with the brush enclosed.
•
After cleaning, first of all place the grinding ring back on to the motor block
(arrow pointing to arrow).
•
Now place the upper grinding mechanism.
•
Turn the grinding ring clockwise to the requested grinding degree.
16