Kospel SVK Serie Mode D'emploi page 11

Application
SVK buffer tank is intended for heating water and/or cold storage with co-opeartion with
central heating boilers and heat pumps. Additionally, buffer tanks may also perform the
following function: divider (hydraulic clutch), hydraulic seperator, heating circuit from
the boiler room.
A buffer tank is made of black steel sheet, the inner surface of the tank is a raw steel.
SVK buffer tank has a thermal insulation.
The maximum working pressure of buffer tank is 0,6MPa.
Assembly and operating instructions
- Read and strictly follow this assembly and operating instructions to ensure a long
life and reliable buffer tank operation.
- The manufacturer of this buffer tank will not be liable for any damages due to the
failure to follow this assembly and operating instructions.
- The buffer tank must not be installed in rooms where the temperature may drop
below 0°C.
- The buffer tank installation and initial start-up as well as all hydraulic work must
be performed by a quailified installer.
- The buffer tank is designed for standing vertical installation - screw on three feet.
- Connections with water installation must be made in accordance with the legally
binding standards.
- Rated temperature of water in the buffer tank should not exceed 95°C!
- All issues should be reported to the service department.
The buffer tank is suitable for fitting an immersion heater with thermostat (GRW 1.4,
GRW 2.0). The immersion heater must be fitted in cork 1 1/2''. A maximum length of
immersion heater: 360mm.
PL;DE;EN;FR;HU;LV;RU-104_f.1492
EN
11