Westinghouse WGen7500c Manuel De L'utilisateur page 10

COMPONENTS
COMPONENTS
CONTROL PANEL COMPONENTS
1
12
1. Push-Button START/STOP: Push once to
automatically start the engine. Push again to stop
the engine.
2. Battery Switch: Turns battery ON and OFF. Must be
ON before electric or remote start.
3. Data Center: Toggle to show voltage, frequency,
total hour meter, and run/maintenance timer.
4. Main Circuit Breaker: The main circuit breaker
controls total output of all outlets to protect the
generator from overload or short circuit.
5. 120/240 Volt AC, 30 Amp NEMA 14-30R Twist-
Lock Receptacle: Receptacle can supply a
maximum of 30 Amps.
6. 120 Volt AC, 20 Amp Duplex GFCI NEMA 5-20R
Receptacles: Receptacles can supply a maximum of
20 Amps.
DATA DISPLAY
Voltage:
Displays current voltage
output.
METER V-F-T
Mode Button
10 | Westinghouse Outdoor Power Equipment, LLC
2 3
11 10 9
Frequency (Hz):
Displays power output
frequency in Hertz.
Push the Mode button to cycle through
the data display modes.
4 5
8
6. 120 Volt AC, 20 Amp Duplex GFCI NEMA 5-20R
Receptacles: Receptacles can supply a maximum of
20 Amps.
7. 20 Amp AC Circuit Breakers: Circuit breakers
limits the current that can be delivered through the
NEMA 5-20R receptacles to 20 Amps.
8. Ground Terminal: The ground terminal is used to
externally ground the generator.
9. Smart Switch Outlet: Connects the Westinghouse
ST Switch (sold separately) to the control panel.
10. Battery Charging Port: Used to charge the battery
with the included battery charger.
11. Battery Indicator: Indicates that power is ON. Light
will remain illuminated while the unit is ON.
12. CO Sensor Indicator Lights: The CO Sensor
monitors for the accumulation of poisonous carbon
monoxide gas. If increasing levels of CO gas are
detected, the CO Sensor automatically shuts down
the engine.
Lifetime Hours:
Displays the lifetime run
hours.
6
Run Time/Maintenance:
Displays current run time.
Resets to zero when shut
down. Maintenance
reminder displayed
when required.
Maintenance Codes:
P25: Change engine oil
P50: Clean air filter,
Change engine oil
P100: Change engine oil,
clean air filter, replace
fuel filter
7