BH H267 Instructions De Montage Et Utilisation page 11

6
Use suitable clothing and footwear.
Make sure all laces/cords are tied
correctly.
ASSEMBLY INSTRUCTIONS.-
1.-
Take the unit out of its box and
make sure that all of the pieces are
there, Fig.1:
(29) Main body; (56) Main post; (5)
handlebar; (1) Electronic monitor; (18)
Saddle post; (51) Front stabiliser bar
with wheels; (33) Rear stabiliser bar
with adjustable feet; (15) Saddle;
pedals (25R) Right and (25L) Left;
(62) Bottle; (60) Bottle holder; (10)
Bracket cover; (34) screws M-8x70;
(31) Curved washer 8x25x1.5; (30)
Cap nut M-8; (12) Handlebar locking
knob; (64) Pedal assembly key; (65)
Allen key 5mm.
2.- FITTING THE STABILISER
BARS.-
ATTENTION: The assistance of a
second person is required for this
stage of the assembly.
Take the front stabiliser bar with
wheels (51) and place it at the front of
your unit, as shown in Fig.2, insert the
M-8x70 screws (34), fit the washers
(31) and the nuts (30).
Then take the rear stabiliser bar with
the adjustable blocks (33) and carry
out the same assembly operation as
with the front stabiliser bar, tighten up
all of the nuts (30) securely.
3.- ATTACHING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the
letter, fitting these incorrectly could
damage the screw thread on the
pedal or the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right pedal (25R) is marked with
the letter (R).This screws onto the
right-hand crank, also marked with an
(R), in a clockwise direction. Tighten
securely Fig.3.
The left pedal (25L) is marked with the
letter (L).This screws onto the left-
hand crank, also marked with an (L),
in an anti-clockwise direction. Tighten
securely Fig.3.
4.- FITTING THE MAIN POST.-
Bring the main post (56) up to the boss
on the main body, Fig.4, and connect
terminals (54) and (55) Fig.4A. Insert
the tip of the cable sheath (63) into the
cable tension control support (T), as
shown in Fig.4B, pull the sheath (63)
up slightly and insert it into the slot,
see Fig.4D, then fit the main mast onto
the boss on the main body, Fig.4,
taking care not to pinch the cables
and make sure that the tensioning
control (63) operates correctly.
Put bolts (52), along with their washers
(31), Fig.4, making sure that the
handlebar is straight and then tighten
securely.
5.- FITTING THE HANDLEBAR.-
Loosen the handlebar bracket, line the
handlebar (5) up with the main post
(56), Fig.5, then fit the bracket cover
(10).and the handlebar locking knob
(12) and tighten, but make sure that
the handlebar is aligned correctly
before tightening the screws securely.
6.- ATTACHING THE SADDLE.-
Remove screws (17) and washers
(16) from the bottom of the saddle
(15).
11