Specifications; User-Replaceable Parts - Masterflex Digi-Staltic 77310-00 Notice D'utilisation

Output:
Speed:
Maximum torque output:
Speed regulation (all conditions): ±0.3% of full speed
Remote contact closures:
Dispense volume:
Dilute volume:
Input:
Supply voltage limits:
115 VAC
230 VAC
Nominal current:
Remote input:
Display:
Construction:
Control console dimensions:
Control console weight:
Pump drive dimensions:
Pump drive weight:
®
II pump heads: 14.6 cm (5.75 in) deep
Two EASY-LOAD
Environment:
Operating temperature:
Storage temperature:
Humidity (non-condensing):
Altitude:
Noise Level:
Pollution degree:
Chemical resistance:
Environmental protection:
Compliance:
Description
Line cord
115V
230V
PC interface cable
3-1/2 ft (1.1 m) RJ-12 cable
Motor brushes (2)
Fuse (T2.5 A, 250 V, 5×20 mm)
Rubber foot (6)
Belt

SPECIFICATIONS

6 to 600 rpm
12.9 kg•cm (180 oz-in)
28 VDC, 1 A
28 VAC, 1 A
0.1 mL to 8000 L
Sample: 0.1 mL to 100.0 mL
Delivery: 0.1 mL to 8000 L
90 VAC to 130 VAC, 48 Hz to 63 Hz
180 VAC to 260 VAC, 48 Hz to 63 Hz
1.7 A (115 VAC), 0.8 A (230 VAC)
START/STOP +5 VDC, 5 mA
40-character x 2-line backlit LCD
22.6 cm (8.9 in) wide, 16.5 cm (6.5 in) deep, 2.3 cm (0.9 in) front, 6.9 cm (2.7 in) back in height
1.4 kg (3.0 lbs)
23.4 cm (9.2 in) wide, 32.3 cm (12.7 in) deep, 18.8 cm (7.4 in) high
9.1 kg (20 lbs)
0° to 40°C (32° to 104°F)
−25° to 65°C (−13° to 149°F)
10% to 90%
Less than 2000 m (6500 ft)
<70dBA @ 1 meter
Pollution degree 2
(Indoor use — lab, office)
All materials withstand standard cleaning solvents. Materials used in the construction are:
a polyester label, a combined aluminum motor and paint-loc steel controller enclosure, and
an epoxy-based, non-chip paint finish.
Withstands general spills and light sprays (IEC-529 IP22).
UL 508C, CSA C22.2, No. 14
230 V:
EN61010-1 (EU Low Voltage Directive) and
EN61326 (EU EMC Directive)
EN809 (EU Machinery Directive)

USER-REPLACEABLE PARTS

20
Part Number
50001-68
50001-70
22050-54
77095-02
B-1238-0056
B-1115-0043
A-1390-0004-CR
A-1341-0006