SOLAC Optima Station 6.0 Mode D'emploi page 11

K Scale cleaning indicator (red)
L Stand activator and boiler scale cleaning
warning reset button
M On standby indicator (green)
N Water tank release button
O Removable water tank
P Max. water level indicator
Q Transportation lock
R Transportation unlock button
S Filling spout
T Steam activation trigger
U Temperature selection control
V Iron ready indicator
W Soleplate
INSTRUCTIONS FOR USE
BEFORE USE:
Make sure that all products' packaging has
•
been removed.
To eliminate the smell given off by the appli-
•
ance when used for the first time, it is recom-
mended to have it on at full power for 2 hours
in a well-ventilated room.
FILLING WITH WATER:
You must fill the water compartment before
•
turning on the appliance.
Remove the appliance's deposit.
•
Fill the deposit taking care to observe the MAX
•
level (P) (Fig.1 + Fig.2).
Put the deposit back into its housing, ensuring
•
that it is inserted properly.
Check that the safety cap is screwed on tightly
•
before switching on the appliance.
USE:
Unroll the cable completely before plugging it
•
in.
Connect the appliance to the mains.
•
Turn the appliance on, by using the on/off but-
•
ton.
The pilot light (J) comes on.
•
Turn the thermostat control to the desired tem-
•
perature position.
Do not use temperatures higher than those in-
•
dicated on the garments to be treated.
● Temperature for synthetic fibres (
Polyester, Nylon...).
●● Temperature for silk and wool.
●●● Temperature for cotton. (Minimum
temperature for steam ironing)
Max Temperature for linen.
If garment has various kinds of fibres, select
•
the temperature for the fibre that requires the
lowest temperature. (For example, select the
temperature for polyester for an article made
out of 60% polyester and 40% cotton).
Wait until the steam ready light (J) comes on.
•
If the red scale cleaning light is on (K) proceed
•
immediately with the boiler descaling process,
see CLEANING section, and then after clean-
ing press the reset button (L) to restart the cy-
cle again.
DRY IRONING:
The appliance has a steam activation trigger,
•
which if not pressed makes it possible to iron
dry (without steam).
STEAM IRONING:
It is possible to iron with steam whenever the
•
deposit is filled with water and the adequate
temperature is selected.
STEAM FLOW CONTROL:
The appliance has a control knob (S) that al-
•
lows to get the control of the steam flow.
VERTICAL STEAMING:
It is possible to iron hanging curtains, items of
•
clothing on his hanger, etc. To do so, follow the
instructions:
Select the maximum temperature of the iron,
•
while turning the temperature regulator of the
iron in a clockwise direction (U
Move the iron in a top to bottom direction while
•
pressing the steam control (S). Important: for
cotton and linen, its recommended to put the
iron base in contact with the material. For oth-
er more delicated fibres, it's recommended to
keep the iron base at some centimetres of dis-
tance.
During extended periods of vertical ironing,
•
drops of water may come out of the soleplate,
put the iron back in the horizontal position, wait
a few seconds and then continue normally.
STAND-BY FUNCTION:
In order to save energy, the appliance passes
•
to stand-by after 8 minutes if the user does not
use it.
The auto-disconnection light (M) will blink to
•
indicate that this function has activated (green
color).
To turn it on again, you simply have to press
•
the on/off button.
EN